forum.heli-x.info

You may update to revision 1906:

- small chnages in the StickMover configuration.
- filter in the plane selection improved.

Thank you for your feedback.

Michael

please try to configure them new

Cross-wind sensitivity is much better now. Extra 300 is a little bit wobbly at ground, if you use the rudder to be on track during take-off. Is this the intended behavior? In my opinion, Extra 300 needs more wind-resistance. What do the other testers say? There is a complete rework in 1903. Hope it...

I've configured a switch for autorotation. In conjunction with planes, switching to autorotation turns off the smoke of the engine, but the prop does not stop spinning. It would be nice, if the engine stops completely, and thrust becomes zero (not reducing idle speed as seen in the status bar). Thi...

Dialog "Model Selection" shows some German words after switching from language German to English (e.g. the dialog title). Other dialogs not tested. After restart of HELI-X the problem is fixed. If you cannot guarantee an on-the-fly language selection, you should show a message "You have to restart....

Ground friction for Easy Star and Easy Star Ailerons should be fine tuned. - on asphalt the friction is too small - on grass the friction is too big It's a kind of comprimise which I let for the moment With throttle idle on ground, the smoke of the Piper should be blown backwards by the prop. Smoke...

Brian wrote: ↑

10 Feb 2019 18:44

Micheal, for gliders the wind noise is okay. Possibly you can manage to increase the volume of the wind noise for motorized aircrafts if throttle is idle. This would be more realistic, because the engine is normally much louder than the wind noise.

Will be reduced.

- In a crash, it sometimes happens that they strange catapulted into the air - The motor sound is great, the wind noise is still too loud (my opinion) Only bug found: - The selection picture for the Piper is wrong Improving the Crash behavior is skipped to 8.x Wind sound will be reduced in the mode...

You may update to rev 1903.

New:
- Improved wind reactions on ground
- Smoke should not move below the earth's surface
- Support of Stick-Mover implemented.

This revision might be release cadidate #1

Thank you for our feedback.

Michael

Hello,

you may update to revision 1900. New:

- For those who have no trim switches on the controller there is now the possibility to set trim settings and store them to each model if wished.
- Stick Mover support prepared.

Thank you for your feedback.